Length (and where to source) laces for vintage knee-high 17-hole boots?
March 19, 2018 7:25 PM
Cleaning out my closet after many years of thrifting, I discovered a handsome pair of 1920s-era knee-high leather boots--but unfortunately without laces. I am a short lady, so "knee height" is 14" from the sole to top of the boot. The boots have 4 eyelets and 13 hooks, so 17 holes total. What is the proper length of a boot lace to tie these boots, and where can I purchase a pair, ideally in black leather to match the boots? I searched the interwebs, but all the charts I found stopped a few holes shy of 17.
How about a local shoe repair place? Barring that, you could get shoelace-width black leather thong at Michael’s or similar craft store for a few bucks.
posted by Autumnheart at 7:56 PM on March 19, 2018
posted by Autumnheart at 7:56 PM on March 19, 2018
Use a ball of twine to lace your boots the way you like, then measure that. And if you don’t have a ball of twine, you should get one, because they are inexpensive and useful.
posted by SaltySalticid at 8:17 PM on March 19, 2018
posted by SaltySalticid at 8:17 PM on March 19, 2018
Most work wear stores sell leather laces (for welders). The leather laces I've seen don't have any furrell at the end so can just be cut to length.
posted by Mitheral at 9:54 PM on March 19, 2018
posted by Mitheral at 9:54 PM on March 19, 2018
I haven't seen anything specifically about 17 hole boots, but Dr Martens recommends 240cm (95") laces for 18-20 hole boots. Theirs are only $3 if you decide you're okay with normal round laces, but otherwise I've found leather laces that long on amazon or ebay.
posted by escapepod at 1:57 AM on March 20, 2018
posted by escapepod at 1:57 AM on March 20, 2018
If you do go with cut-to-measure leather thongs for laces, which would be my recommendation as the cheapest and easiest solution, you can buy metal aglets (the end bits) online to finish them and make lacing easier.
posted by ananci at 1:27 PM on March 20, 2018
posted by ananci at 1:27 PM on March 20, 2018
« Older What's in the cancer research pipeline? | Looking for the name of an out of business shop in... Newer »
This thread is closed to new comments.
posted by cobaltnine at 7:31 PM on March 19, 2018