It looks thusly. My issue is that, despite the fact that it was originally barely taped down at all, I am unable to successfully, reliably reattach it using the same method. ("it" in this case being the printed black strips on the left). I am reasonably sure that lack-of-contact is my problem, because if I physically hold the cable to the board, it will reliably work when I push a button. Best I can do is that sometimes, after putting it all back together for the Nth time, one button will work. Maybe other buttons on its side will work, maybe not. Maybe it'll work for a few presses and then quit. The cable looks fine, the board contacts look fine, no amount of scotch tape is helping me out here. How do I affix these suckers but good?
Is there a reason Malvino's Electronic Principles would be considered a bad book? [more inside]
Looking for somewhere to buy electronic components in Los Angeles, possibly in bulk ammounts. Things like resistors, capacitors, op-amps, LEDs. I'm imagining a great big store with aisles and aisles of switches, knobs, project enclosures, components, wires and soldering irons. [more inside]
Just returned from fabulous 2 week holiday in New York. I Brought back Epson Artisan 800 All-in-One Printer from Staples costing $230. Unfortunately, I cannot use it in U.K., unless I plug voltage converter/transformer products. Has anyone else bought this set over there with more success? Any advice \ information appreciated. Please specify me What exact voltage converter product to buy & where to buy it from USA online store. Thanks. [more inside]
Anyone know of any non-Radio-Shack retail outlets for electronic components near Philadelphia? I know there are tons of online outlets, but I'm looking for a brick and mortar supplier, and I need more variety than Radio Shack can offer.
Please tell me everything you know about MIDI over Ethernet or MIDI over IP. [more inside]
Tips for hand soldering leads to printed flexible circuits? [more inside]